DataPLUS, a new module providing data subsets covering joints information, lubricants and coolants, material dimensions, tribology, and coatings information helps drive even more accurate material selections! Click here to see more. Total Materia Tips and Tricks 6 th September
Mechanical water pump or electric? Maintaining an optimum operating engine temperature is key no matter the application, and both styles of pump, in essence, accomplish the same task, but they do so in much different ways and with significant and not-so-significant tradeoffs. By and large, your decision rests on the intended use of the vehicle — is it a racecar or is it a street car?
Back to Information about steel strip. Now, the both technologies have since long achieved worldwide recognition. Though there are slight differences in the layouts of the two strip production technologies, they both cast the steel into a thin gage, reheat it, and roll it into finish gage in a limited number of passes, thus great reduce the production stages and lower the energy consumption.
Please take this quick survey to tell us about what happens after you publish a paper. The Hazelett Strip-Casting has the attractive advantage of rapid change of slab width and thickness. It was demonstrated during our program that width was easier to change than thickness. From our experience, machine operation was good and attention was required only for routine mechanical maintenance and belt replacement.
We can supply rolled products such as strip, sheets, and plates made of brass, copper, bronze, aluminum, and nickel silver at short notice. Take advantage of our flexibility! Depending on the order volume, we can supply you either from a cutting center or directly from the factory.
Demand for brass radiator strip is increasing strongly in South-East Asia, notably in Thailand. Outokumpu Copper Strip is therefore introducing continuous vertical casting of brass radiator strip at its Zutphen plant in the Netherlands. Annual production there will increase to 50, tonnes.
The production of hot strip is a key element of steel production. Since close to half of all steel produced is hot-rolled to strip, mills require maximum throughput and availability combined with geometrical precision and the ability to create optimum material properties. Ever since Primetals Technologies was the first in the world to develop a SSP, we have maintained our position as a pioneer in the field.
Additionally, previously, inIngeteam Power Technology also obtained the order for a new It has transformed the world of flat steel production for carbon steel due to high cost efficiency, a wide product variety and outstanding strip quality. See phone industry ingeteam.